Skip to content

Quinlan · Royse City · Caddo Mills · Rockwall

Fully insured, over 10 years on the job. Free quotes at (903) 320-5534

(903) 320-5534

ServicesEntry Doors

Entry Doors in Quinlan, TX

We replace worn, drafty or sticking front doors with new entry doors that are set square, sealed tight and finished inside and out. We check the frame and sill first, give you a clear written quote, and leave your entry clean when we're done.

Two installers carry a dark fiberglass entry door with decorative glass and sidelites toward the open front doorway of a brick house, with a ladder nearby.

When it's time for a new front door

Your front door works harder than anything else on the outside of your home. It opens and closes thousands of times a year, takes sun and rain straight on, and carries the lock you count on every night. Once the slab has warped, the frame has gone soft or the weatherstripping no longer meets the door, a new prehung unit replaces the slab, frame, sill and seals in one job.

The heavy clay soil in this area swells after a wet spell and pulls back in the heat of summer. Houses shift along with it, and a door usually shows that first, with a latch that misses the strike or a thin line of light at one top corner. We look for that kind of movement before we measure, then shim and set the new door so it stays square.

We put in fiberglass and steel doors, plain or with sidelites and transoms. And if your old door is still sound, we'll say so and leave it be.

What the work includes

A full prehung unit

We replace the slab and frame together, not just the door. You get a new sill, new hinges and factory-set weatherstripping that actually meets the slab.

Fiberglass or steel

Fiberglass doesn't dent, handles sun without warping, and can be stained to look like wood. Steel costs less and is very strong, but it can dent and runs hot in direct sun. We'll show you both.

Sidelites, transoms and glass

Many entries have glass beside or above the door. We can match that layout or change it, with clear, privacy or decorative glass that's low-E to cut heat.

Sill pan and flashing

Water that slips under a threshold rots the subfloor. We set the sill on a pan and flash the sides before the door goes in.

Hardware and lock setup

We install the lockset and deadbolt you pick and adjust the strike so the door latches without a shove.

Trim, caulk and cleanup

We replace interior casing and exterior brick mold as needed, caulk and seal every joint, and haul the old door away.

How to tell your entry door needs replacing

  • Light showing at the edges

    Shut the door and look along the top, sides and threshold. Any light you see means outside air and dust are coming through, and your AC works harder all summer.

  • Sticking or a latch that misses

    When the door rubs the frame or you have to lean on it to turn the deadbolt, the frame has most likely shifted out of square.

  • Spongy frame at the bottom

    Push a screwdriver tip into the jamb a few inches above the floor. If the wood gives way, moisture has worked in behind the trim and rot has set in.

  • Slab that's bowed, split or dented

    Years of sun make wood doors crack and bow. Steel doors pick up dents and rust at the lower edge. Either way, the door stops sealing against the weatherstripping.

  • Cloudy glass in the door or sidelites

    Haze or moisture trapped between the panes tells you the seal is gone. That glass has lost most of its insulating value.

How an entry door job runs

  1. 1

    Free in-person consultation

    We come out, look at the door, frame, sill and the floor under it, and take exact measurements. You see samples and get a written quote with each line spelled out. If your city requires a permit, we pull it.

  2. 2

    Ordering your door

    Most entry doors are built to order. We tell you the expected lead time when we place the order and call you when the door arrives.

  3. 3

    Install day

    We lay drop cloths and protect the floor inside your entry. The old door comes out, we check the opening and subfloor, and if we find damage we show you before fixing it. The new unit goes in on a sill pan, shimmed plumb and fastened tight.

  4. 4

    Finish and walk-through

    We set the hardware, adjust the latch and weatherstripping, then caulk and trim. Before we leave, we show you how it locks and seals and take the old door with us.

What sets the price of a new entry door

No two front entries are quite alike, so we quote yours after we've stood in front of it. The written quote breaks out the door, glass, hardware and labor line by line, so nothing is lumped together. If paying all at once is a stretch, ask about our 0% Financing options or $0 Down on the whole project.

Steel or fiberglass
Steel sits at the lower end. Fiberglass runs higher, and a wood-grain fiberglass slab you can stain adds a little more on top of that.
How much glass
A plain solid slab keeps things simple. Adding sidelites, a transom or decorative glass brings more material and more hours.
Keeping or changing the opening
Most new doors drop into the opening you already have. A wider door or new sidelites means reframing, and with brick around it, cutting and patching the masonry.
Hidden damage at the sill
If the subfloor or framing under the threshold has rotted, it gets fixed before the new door goes in. We photograph it, walk you through it and wait for your go-ahead.
Locks and permit fees
A smart lock or a heavy handleset costs more than a standard knob and deadbolt. Where your city requires a permit, the fee shows up as its own line on the quote.

Entry door questions

Something not covered here? (903) 320-5534

Should I pick fiberglass or steel?

For most homes we lean toward fiberglass. It won't dent from spring hail or a moving dolly, it doesn't rust at the bottom edge, and it holds up to hard afternoon sun. Steel is a fair choice under a covered porch if budget matters most. We bring samples so you can see and feel both.

Will you have to tear out my brick?

Usually not. Most replacements fit the existing rough opening, so the brick stays as it is. If you want a wider door or added sidelites, the opening has to change, and we'll explain what that involves before you decide.

Will my house be open while you work?

Only for part of the day. We don't pull the old door until the new one is on site and checked over. By the time we pack up, the new door is in, locked and sealed.

Can I keep my current lock and handle?

Sometimes. If the hardware is in good shape and fits the new door, we can reuse it. Most people choose new hardware because the old finish rarely matches a new door, but that's your call.

What happens to my storm door?

It comes off for the install. If it fits the new frame and is in good shape, we put it back. If not, we can fit a new one, and our Storm Doors page covers the options.

See what a new front door would look like on your home

We'll come out to Quinlan or nearby towns like Royse City and Caddo Mills, look at your entry, and give you a written quote. No pressure to decide that day.